RUBBER SPLICING

RUBBER SPLICING is available in the following materials: VITON SILICONE FLUOROSILICONE NEOPRENE EPDM HYPALON BUTYL NITRILE SBR POLYURETHANE SPONGE and NATURAL RUBBER

Call or Email Us with the Catalog Number Below For A FREE Quote
1-800-AAA-ACME • info@acmerubber.com

EXTRUSION • STRIP • SHEETING

AAA-ACME will custom design SPLICED parts to your specifications. We will review your requirements and help refine your ideas into finished parts. Through exploring alternative methods and fabrication techniques, AAA-ACME will offer a superior part at a lower cost.

The BUTT SPLICE is used for fabricating endless gaskets where there will be limited or no strain on the splice.

The BIAS SPLICE is an alternate to the butt splice and is used where the cross sectional area is insufficient to form a suitable bond by using the butt splice.

The STEP SPLICE provides maximum bond strength permitting nominal deformation under compression or tension when used as a static seal.

The CORNER SPLICE is used to form gaskets of special configurations. Spliced corners provide a satisfactory static seal where the splice is not under strain.

MOLDED SPLICES - many gaskets may be produced economically by splicing extruded shapes to form complete gaskets.

Materials Available	Production Capabilities	Rubber Extrusions
Tube & Cord, Squares & Rectangles	Rubber Sheet	AAA-Acme Rubber TO HOME

Toll Free 1-800-AAA-ACME • Tel 480 966-9311 • Fax 480 966-2273
2003 E. Fifth St., Bldg. #1, Tempe, AZ 85288
Email: info@acmerubber.com

employment opportunities

Information provided is given in good faith but without warranty, express or implied. Performance of these elastomers is dependent on conditions of use and it is the responsibility of the user to determine suitability for a particular application. Hypalon, Kalrez & Neoprene are trademarks or registered trademarks of E.I. du Pont de Nemours.
Viton is a trade mark of Chemours.

Scroll above for information on Rubber Splicing